A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
ABS pump and control module Ford Ranger JB3C2C405AE 0265956579
Vendors's code: JB3C2C405AE
Product code: 0265956579
Barcode:
Code 39:
ISBN:
€325.20
Price
€325.20
€400.00
Price
€400.00
In stock
Ask about the product
ABS pump and control module Ford Ranger JB3C2C405AE 0265956579
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
€30.00
-
shipping
(Poland)
from
€30.00
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
ABS pump for the Ford Ranger - what to check before buying?
This is a used, working ABS pump with control module for the Ford Ranger - numbers JB3C-2C405-AE / JB3C2C405AE; 0265956579. Before buying, compare the numbers with the label on the module in your car.
ABS pump and control module Ford Ranger
If the ABS warning light is on in your Ford Ranger or the brake system reports faults, the pump with control module may be the cause. We sell a used, working unit in good condition.
Numbers to compare
- JB3C-2C405-AE / JB3C2C405AE - part number (OEM)
- 0265956579 - ABS control module number (Bosch)
Application according to the listing
- Ford Ranger - model
- Bosch - manufacturer
How an ABS pump with control module works
The valves in the hydraulic block open and close many times per second, and the control module monitors their operation continuously. A failure of any of these parts turns on the ABS warning light.
Matching
For this model we offer several pumps with different numbers. The number on the label decides, not the model name alone. The electronics and the hydraulic block are matched to each other, so we treat the listing as a set that should be compared with the original by its numbers.
Symptoms of a faulty ABS pump
- the ABS and brake warning lights do not go out after switching on the ignition,
- no wheel speed reading,
- the car reports sensor faults even though the sensors work,
- the module overheats or resets.
Remember that after replacement the module may need coding or adaptation - check this for your model.
Questions and answers
| What condition is this part in? |
|---|
| It is a used, working part in good condition. Please send any questions about its condition to us before buying. |
| Which number matters most when choosing? |
| It is best to compare all the numbers on the module, above all the one marked as the manufacturer or OEM number. |
| How can I check whether the pump will fit my car? |
| Compare the model, year and the numbers on the module fitted in your car with the numbers in the description. You can also send us a photo. |
Write to contact@auto24parts.com with the model, year and the number from your pump - we will check the fit.
