Rover ABS Pumps and Control Modules

Rover ABS Pump: Hydraulic Module with ABS Control Unit

An ABS pump in a Rover is an aluminium hydraulic block with valves and a pump motor, together with a control unit that reads the signals from the wheel speed sensors. On many models the same module also handles the stability control system, so a fault sometimes shows up as more than just the ABS warning light. The module is usually sold and replaced as a single unit.

Our range changes regularly, and below we give examples from the current range. Among them you will find original numbers, as well as Bosch numbers (0 265 ... and 0 273 ...).

Rover 25 and 75 ABS Pump

Our range includes, among others, modules with the following numbers:

• Rover 25 ABS pump, number SRB101210,
• Rover 75 ABS pump, number 0265224009,
• Rover 75 ABS pump, number 0265222001,
• Rover 75 2.0 CDTI ABS pump, number 0265222001,
• Rover ABS pump, number 0265216519.

The listings do not always state the year of the car, so compatibility depends on the number from the original pump.

How to choose an ABS pump for a Rover by part number

Model and year are not enough, because the same model comes with different versions of the module, depending on the engine, drive and equipment level. In our range you will find several kinds of numbers:

• the original number, for example SRB101210,
• the manufacturer's number for the hydraulic block, for example Bosch 0 265 2xx xxx,
• the control unit number, for example Bosch 0 265 8xx xxx or 0 273 004 xxx.

Compare all the numbers with the original pump in your car and, if in doubt, write to us before buying.

Symptoms of a faulty ABS pump or control unit

• the ABS warning light comes on after the engine is started and does not go out,
• the ABS stops working, although basic braking usually remains functional,
• the brake pedal pulses or feels uneven for no obvious reason,
• the control unit stores valve, pump motor or communication faults,
• brake fluid leaks from the hydraulic block, which requires immediate action.

Before deciding on a replacement, check the wheel speed sensors, their wiring and the supply voltage. After replacing the module, the fault codes usually need to be cleared, and after disconnecting the brake lines the system must be bled. On some models the module also needs adaptation in the control unit, so installation is best left to a workshop with a suitable diagnostic scanner.

Used original ABS module: condition and inspection

We sell used original ABS modules, not new parts. Every item is inspected and tested before sale, and the product photos show the look of the block, the numbers and the labels, so you can compare them with your own pump.

Related electronic parts

If you are looking for other modules, see ABS / ESP / ASR control units and electronic car parts.

Ordering, Payment, Delivery and Warranty

Information about placing an order is available on the How to Buy page. The available payment methods are described under Payment Methods, while shipping information can be found on the Shipping and Delivery page.

Our rules on returns, complaints and warranty are set out on the Returns, Warranty and Complaints page. Further answers are also available in the Auto24Parts FAQ.

FAQ: Rover ABS Pump