A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
ABS pump Mercedes ML ATE 10021096861
Vendors's code: 10021096861
Product code: F8E9-325FB
Barcode:
Code 39:
ISBN:
€406.50
Price
€406.50
€500.00
Price
€500.00
Ask about the product
ABS pump Mercedes ML ATE 10021096861
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
€30.00
-
shipping
(Poland)
from
€30.00
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
What does number 10021096861 on an ABS pump mean?
Used original ABS module with number 10021096861 for Mercedes ML. Confirm compatibility with the number from your original pump.
Is ABS pump 10021096861 the right part for your Mercedes?
ABS pump 10021096861 for Mercedes ML is a used original module that regulates brake pressure when a wheel starts to lock up. It is matched by the numbers on its labels, not by the car model alone. According to the listing, the pump comes from the Mercedes ML model.
Part number 10021096861 and related numbers
The numbers from the listing, as written on the labels and as a single string:
- 10.0210-9686.1 (catalogue format: 10021096861), hydraulic block manufacturer's number.
Check the numbers on your pump and compare them with those above. If any of them differs, contact us before ordering.
Symptoms of a faulty ABS pump or control unit
- the ABS warning light comes on after the engine is started and stays on,
- the ABS stops working, although basic braking usually remains functional,
- the ABS warning light comes on together with the stability control warning light,
- the ABS switches itself off shortly after the engine is started.
Before buying a module, read the fault codes with a diagnostic tester. A faulty wheel speed sensor or its wiring can cause the same symptoms, and in that case replacing the pump will not help. After replacement the fault codes usually need to be cleared, and if the brake lines have been disconnected, the system must be bled.
Questions and answers
| Does a lit ABS warning light always mean a faulty pump? |
|---|
| No. Read the fault codes first, because the cause may be a wheel sensor, its wiring or too low a supply voltage. |
| Do the brakes need bleeding after replacing the module? |
| If the brake lines are disconnected during fitting, the system must be bled. The fault codes in the control unit usually need to be cleared as well. |
| Who makes this module? |
| The module is made by ATE. The manufacturer's name does not change the numbers you should use to match the part. |
| What condition is this ABS module in? |
| It is an original recycled part in good condition, checked by us. Warranty details are in the product features table. |
Not certain this is the right module? Send us the numbers from the label on your pump and we will help you compare them.
