A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
ABS pump and control module Opel Insignia 13313805 16312209H
Vendors's code: 13313805
Product code: 54085326C
Barcode:
Code 39:
ISBN:
$83.18
Price
$83.18
$102.31
Price
$102.31
In stock
Ask about the product
ABS pump and control module Opel Insignia 13313805 16312209H
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
$30.69
-
shipping
(Poland)
from
$30.69
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
Opel Insignia - is this the right ABS pump for your car?
This is a used, working ABS pump with control module for the Opel Insignia - numbers 13313805; 16312209-H / 16312209H. Before buying, compare the numbers with the label on the module in your car.
ABS pump and control module Opel Insignia
An ABS pump with control module is one of the key active safety components. This listing applies to: Opel Insignia; the part is used, working and in good condition.
Numbers to compare
- 13313805 - part number (OEM)
- 16312209-H / 16312209H - part number (OEM)
- 54085326C - part number (OEM)
Application according to the listing
- Opel Insignia - model
How an ABS pump with control module works
The module is connected by brake lines to the master cylinder and to the wheel circuits. That is why cleanliness must be maintained during replacement and the system must be bled thoroughly.
Matching
We also offer other pumps for this model with different numbers. Choose by the number on the module, not by the model alone. The brake system is critical for safety, so fitting is best left to a workshop that will bleed the brakes and check ABS operation.
Symptoms of a faulty ABS pump
- ABS does not react to wheel slip,
- ESP or ASR does not switch on,
- power supply faults in the diagnostic memory,
- signs of corrosion are visible on the connector.
Start by checking the fuse and connectors; replace the pump only when the wiring and sensors are in working order.
Questions and answers
| What condition is this part in? |
|---|
| It is a used, working part in good condition. Please send any questions about its condition to us before buying. |
| Where does this part come from? |
| The pump is used and comes from a dismantled vehicle. We give the manufacturer and OEM numbers in the description so that you can compare them. |
| Where can I find the number on the module? |
| You will usually find the numbers on the label or housing of the module, visible after removing it from the car. If you cannot read them, send us a photo. |
Send a photo of your ABS pump or its number to contact@auto24parts.com and we will confirm whether this part will fit.
