A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
ABS pump and control module Volkswagen Audi ATE 5WA614517BK 10022024054 5WA614517P 10091803653
Vendors's code: 10022024054
Product code: 7A72-1143B
Barcode:
Code 39:
ISBN:
$204.91
Price
$204.91
$252.04
Price
$252.04
Ask about the product
ABS pump and control module Volkswagen Audi ATE 5WA614517BK 10022024054 5WA614517P 10091803653
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
$30.24
-
shipping
(Poland)
from
$30.24
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
How do you match ABS pump 5WA614517BK to your car?
Compare two VAG numbers: 5WA 614 517 BK from the sticker on the pump motor and 5WA 614 517 P from the control module label. We are selling a genuine ATE assembly, used and in working order, intended for Volkswagen and Audi.
ATE hydraulic unit 5WA614517BK with module 5WA614517P
The markings on this unit fall into two groups. The VAG numbers - 5WA614517BK for the hydraulic unit and 5WA 614 517 P for the control module - are the ones workshops use when matching parts. The ATE numbers describe the components from the manufacturer's side: 10.0220-2405.4 is the hydraulic block, while 10.0918-0365.3, 10.0633-3090.1 and 28.5164-6038.3 appear on the control module label, next to the words ‘Controller’ and ‘Steuergeraet ESC’. You will find the marking ‘MK100ESC’ on the pump sticker.
Full list of numbers
- 5WA614517BK - VAG number of the ABS pump (hydraulic unit), on the sticker on the pump motor: 5WA 614 517 BK
- 10022024054 - ATE number of the hydraulic block (pump), on the sticker on the pump motor: 10.0220-2405.4
- 5WA614517P - VAG number of the ABS/ESP control module, on the control module label: 5WA 614 517 P
- 10091803653 - ATE number from the control module label: 10.0918-0365.3
- 10063330901 - ATE number from the control module label: 10.0633-3090.1
- 28516460383 - ATE number from the control module label: 28.5164-6038.3
The sticker with DataMatrix codes on the pump motor gives the unit numbers, and next to it you can see the port markings HZ1, HZ2, VL, VR, HL and HR. The VAG number of the control module starts in the same way as the pump number - only the suffix (BK and P) differs, so do not mix the two up. The shop also has another version of this pump with a different suffix.
Symptoms that make it worth checking the unit
Problems with the ABS assembly are usually signalled by:
- ABS and ESP warning lights on at the same time,
- ABS inactive under braking,
- a pump fault code in the control module memory.
Before you replace the unit, check the fault codes with a diagnostic tool, followed by the wheel speed sensors, fuses, electrical connections and battery. After fitting, bleed the brake system; module coding and calibration of the steering angle sensor and the ESP sensors are often needed as well.
Questions about pump 5WA614517BK
| Which car does this assembly fit? |
|---|
| Volkswagen and Audi. The model is not confirmed - matching VAG numbers for the pump and control module are what decide. |
| What is the condition and warranty? |
| A genuine ATE part, used and in working order. The warranty period is given in the product features table. |
| Do the brakes need bleeding after fitting? |
| Yes - after the unit is fitted, the brake system needs bleeding. |
| Which number should I check first? |
| The VAG pump number 5WA 614 517 BK, including the letters at the end. The other numbers help to confirm compatibility. |
Take a photo of the pump sticker and the control module label, or give us your VIN, and we will check whether this unit will fit.
