A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
Engine Control Unit Skoda Fabia 1.4 Magneti Marelli IAW 4TV.KE 036906034KE 6160031301
Vendors's code: 6160031301
Product code: 036906034KE
Barcode:
Code 39:
ISBN:
£123.58
Price
£123.58
£152.00
Price
£152.00
Select a product option:
Individual variants may differ in price
product option
Important: Depending on the ECU type and vehicle model, not all of the options listed below may be available.
To select the correct option for your vehicle and ECU, please contact us before purchasing:
contact@auto24parts.com
1. Locked
This option is intended for professional workshops with the required specialist equipment and technical knowledge.
The ECU has been removed from a vehicle intended for recycling and still contains the immobilizer data and other information from the previous vehicle. Before it can be used in another car, it must be unlocked and then programmed using specialist automotive diagnostic equipment.
2. Unlocked
Several preparation methods may be available. The possible options depend on the ECU type, vehicle model and immobilizer system. Please contact us before purchasing, as some preparation methods are not available for every ECU.
Our electronics specialists can prepare the ECU in one of the following ways:
a) ECU with PIN code (Car Pass)
The PIN code is supplied, but programming with a suitable diagnostic tool is still required. After installing the ECU, it must be reset using the supplied PIN code and then programmed to the vehicle’s immobilizer system.
b) VIRGIN ECU
The data from the previous vehicle is removed and the ECU is restored to a clean, factory-like state. After installation, it must be programmed to the vehicle using a compatible specialist diagnostic tool. Unless another preparation method is specified in the product description, this is the standard unlocking option for most of our ECUs.
c) Plug & Play – IMMO OFF
The immobilizer function is disabled in the ECU. After installation, the engine can start without additional immobilizer programming. Please note that the vehicle will no longer have an active immobilizer function, and an immobilizer warning light or fault code may remain, depending on the vehicle model.
d) Plug & Play – Automatic Programming
After installation, the ECU automatically learns and saves the required vehicle data. No additional programming is normally required.
e) Plug & Play – 1:1 Clone
The data from your original ECU is copied to another fully functional ECU. The cloned unit is then ready for installation without additional programming.
You must send us your original ECU so that we can transfer its data to the replacement unit.
The original ECU must have working communication with the vehicle, a diagnostic tool or our programming equipment. If the required data cannot be read, a complete 1:1 clone may not be possible.
3. Complete Plug & Play Set
A complete matched set containing the ECU, immobilizer components and all other parts required to start the vehicle without additional programming. All components supplied in the set must be installed in the vehicle.
Important:
Dispatch time depends on the selected option. If an unlocked or specially prepared version is ordered, the preparation service usually requires an additional 1–2 business days.
Ask about the product
Engine Control Unit Skoda Fabia 1.4 Magneti Marelli IAW 4TV.KE 036906034KE 6160031301
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
£22.80
-
shipping
(Poland)
from
£22.80
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
How can you check whether ECU 036906034KE will fit a Fabia 1.4?
Simply compare two numbers on the sticker: VW 036906034KE and Magneti Marelli 61600.313.01. If they match, this used, fully working IAW 4TV.KE ECU will replace the unit in your 1.4 petrol Fabia.
Engine Control Unit Skoda Fabia 1.4 Magneti Marelli IAW 4TV.KE 036906034KE 6160031301
The simplest way to find the right unit is to compare the label – and that is the place to start with this Magneti Marelli IAW 4TV.KE ECU. Unit 036906034KE comes from a Skoda Fabia with the 1.4 petrol engine, where it managed injection, ignition and idle. It is used, fully working and in good condition.
Numbers on the sticker
- 036906034KE – VW/Skoda part number, version KE
- 6160031301 – Magneti Marelli number, on the label 61600.313.01
- IAW 4TV.KE – ECU type
Related versions such as KM or JE belong to the same 4TV family but have different software. That is why the letters KE must match. If the label is illegible, a diagnostic tool connected to the car can also read the VW number.
Symptoms that may point to the ECU
- no start even though the starter motor and fuel pump are working,
- intermittent loss of power and jerking,
- stored internal faults in the engine unit,
- no connection to diagnostics after a voltage spike.
The first steps are to check the fuses, earths and connector – only suspect the unit once they are in order.
Unlocking: your garage or us?
If your garage will carry out the unlocking, programming and adaptation, choose the locked version – it contains the previous Fabia's data and immobiliser. If you would rather we did it, order the unlocked version; we prepare it before dispatch, usually within 1–2 working days.
The range of possible methods – PIN / CAR PASS, Virgin, IMMO OFF, auto programming, cloning – depends on the part number, software and immobiliser. Please ask before ordering. Full information: ECU options explained.
Questions and answers
| Will 036906034KE replace ECU 036906034KM? |
|---|
| Do not assume so – they are different versions from the 4TV family. |
| How is the Magneti Marelli number written on the label? |
| As 61600.313.01, i.e. 6160031301 with dots. |
| What condition is the ECU in? |
| Used, fully working, in good condition. You will find the warranty period in the product specification table. |
Send the numbers to contact@auto24parts.com – we will check whether this is the right unit for your Fabia.
