A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
Engine control unit MAN L2000 0281010260
Vendors's code: 0281010260
Product code: A83A-816EF
Barcode:
Code 39:
ISBN:
$457.48
Price
$457.48
$562.70
Price
$562.70
In stock
Ask about the product
Engine control unit MAN L2000 0281010260
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
$30.69
-
shipping
(Poland)
from
$30.69
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
How can you check whether this control unit will fit your MAN L2000?
An engine control unit in working order for the MAN L2000 - numbers 0 281 010 260 / 0281010260, a used part in good condition. The numbers on the label decide the match, so compare them with those on your own control unit.
Engine control unit for MAN L2000
According to the listing data, this electronic module fits the MAN L2000. This is a used part in working order and in good condition - match it using the numbers in the list.
Part numbers in this listing
- 0 281 010 260 / 0281010260 - manufacturer's number - Bosch
Car and engine according to the listing
- MAN L2000 - model
- Bosch - manufacturer
The role of the control unit in the engine
The control unit reads signals from the crankshaft position, temperature, pressure and airflow sensors, then calculates the fuel quantity and injection timing. This allows the engine to run steadily in a range of conditions. Damage can result from water ingress, a voltage surge or wear of the electronic components, and it can show up intermittently.
How to match this part
Compare number 0 281 010 260 in full with the number on your control unit. Different versions were fitted to the same models, so it is the number that decides the match, not the model alone. Before buying, compare all the numbers with the label on your control unit, both with spaces and as a single string.
Symptoms of a faulty control unit
- the engine warning light is on straight after the ignition is switched on,
- the diagnostic tester cannot connect to the control unit,
- engine speed is displayed incorrectly,
- the system works intermittently.
Inspect the control unit connectors: corrosion or burnt contacts cause symptoms similar to faulty electronics.
Locked control unit
We offer this control unit in the locked variant only - an unlocked variant cannot be selected in this listing; if you would like us to prepare it, ask us before buying. A locked control unit is sold with the previous vehicle's data - this is an option for workshops that can unlock and program it. Not all unlocking methods - PIN / CAR PASS, Virgin, IMMO OFF, auto-programming or cloning - are available for every number, as a lot depends on the software and the immobiliser. Before buying, send us the number of your control unit. More details: what locked and unlocked mean for an engine control unit.
Frequently asked questions
| Is the part new? |
|---|
| The control unit is used, but in working order. The warranty is stated in the product features. |
| Can I order an unlocked control unit? |
| This listing has no unlocked variant - we dispatch the control unit locked. Whether an unlocking method is available depends on the number and software, so if you would like us to prepare it, ask us before buying. |
| What should I check on delivery? |
| Check that the numbers match the description and that the connectors and housing show no cracks or signs of corrosion. |
Send a photo of your control unit or its number to contact@auto24parts.com and we will confirm whether this part will fit.
