A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
ABS pump and control module Audi ATE 8N0614217A 10020401494 8N0907379C 10094903783
Vendors's code: 10020401494
Product code: 75E3-715AB
Barcode:
Code 39:
ISBN:
1 626,02 zł
Price
1 626,02 zł
2 000,00 zł
Price
2 000,00 zł
Ask about the product
ABS pump and control module Audi ATE 8N0614217A 10020401494 8N0907379C 10094903783
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
120,00 zł
-
shipping
(Poland)
from
120,00 zł
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
Does ABS pump 8N0614217A fit your Audi?
It does if your pump's sticker shows 8N0 614 217 A and the control module 8N0 907 379 C. We are selling this used, working ATE unit complete with its module.
ATE ABS hydraulic unit 8N0614217A with control module 8N0907379C - Audi
The VAG numbers of different versions of this type of unit can be very similar, and a different ending may mean another version of the system. This module is described on its label as ‘Steuergeraet fuer EDS/Quattro’, and the core number alone is not enough to judge whether it is a replacement. That is why you should compare both 8N0614217A with its final letter A and the control module number.
Numbers from the sticker and label
- 8N0614217A - VAG number of the ABS pump (hydraulic unit), on the sticker: 8N0 614 217 A
- 10020401494 - ATE number of the hydraulic block (pump), as on the sticker: 10.0204-0149.4
- 8N0907379C - VAG number of the ABS/ESP control module, module label: 8N0 907 379 C
- 10094903783 - ATE number from the control module label: 10.0949-0378.3
The pump numbers are on a paper sticker attached to the motor housing - it is worn, so some characters are hard to make out. The control module label carries the wording ‘Controller’ and ‘Steuergeraet fuer EDS/Quattro’. We have one more version of this pump with a different suffix in the shop, so compare the number in full.
When the ABS starts playing up
You will usually see:
- the ABS and ESP lights on together,
- ABS not working under braking,
- a stored pump fault code.
Before buying, read the fault codes and check whether a wheel sensor, fuse, wire, plug or the battery is to blame. After fitting, bleed the brake system and, if necessary, code the module with a diagnostic tool.
Frequently asked questions - 8N0614217A
| Which make does this hydraulic unit fit? |
|---|
| Audi. We do not give the model - you establish the fit by comparing numbers: the pump number 8N0 614 217 A and the control module number must both match. |
| What condition is the part in? |
| Genuine, used and working, from a dismantled vehicle. The warranty period is shown in the product features table. |
| Am I buying the pump together with the control module? |
| Yes, the listing covers the complete unit: the ATE hydraulic block with pump motor and module 8N0 907 379 C. |
| What do the numbers 10.0204-0149.4 and 10.0949-0378.3 mean? |
| They are the manufacturer ATE's designations - the first relates to the hydraulic block, the second comes from the control module label. |
Send a photo of the sticker on your pump motor or your VIN, and we will check whether the numbers match.
