The automatic transmission control unit (often designated as TCU or TCM) is a crucial electronic component responsible for smooth and trouble-free gear shifting. Its failure, most often caused by overheating, short circuits, or water damage, results in jerking, an inability to shift gears, or the vehicle entering limp mode. Purchasing a new module at an authorized dealership is a massive expense, which is why replacing it with a fully functional, used original is the most reasonable solution.
ECU Engine controller Alfa Romeo 159 1.9 JTDM 0281013138 55204661
Vendors's code:
Product code: 56E4-2982E
Barcode:
Code 39:
ISBN:
731,71 zł
Price
731,71 zł
900,00 zł
Price
900,00 zł
Select a product option:
Individual variants may differ in price
product option
Important: Depending on the ECU type and vehicle model, not all of the options listed below may be available.
To select the correct option for your vehicle and ECU, please contact us before purchasing:
contact@auto24parts.com
1. Locked
This option is intended for professional workshops with the required specialist equipment and technical knowledge.
The ECU has been removed from a vehicle intended for recycling and still contains the immobilizer data and other information from the previous vehicle. Before it can be used in another car, it must be unlocked and then programmed using specialist automotive diagnostic equipment.
2. Unlocked
Several preparation methods may be available. The possible options depend on the ECU type, vehicle model and immobilizer system. Please contact us before purchasing, as some preparation methods are not available for every ECU.
Our electronics specialists can prepare the ECU in one of the following ways:
a) ECU with PIN code (Car Pass)
The PIN code is supplied, but programming with a suitable diagnostic tool is still required. After installing the ECU, it must be reset using the supplied PIN code and then programmed to the vehicle’s immobilizer system.
b) VIRGIN ECU
The data from the previous vehicle is removed and the ECU is restored to a clean, factory-like state. After installation, it must be programmed to the vehicle using a compatible specialist diagnostic tool. Unless another preparation method is specified in the product description, this is the standard unlocking option for most of our ECUs.
c) Plug & Play – IMMO OFF
The immobilizer function is disabled in the ECU. After installation, the engine can start without additional immobilizer programming. Please note that the vehicle will no longer have an active immobilizer function, and an immobilizer warning light or fault code may remain, depending on the vehicle model.
d) Plug & Play – Automatic Programming
After installation, the ECU automatically learns and saves the required vehicle data. No additional programming is normally required.
e) Plug & Play – 1:1 Clone
The data from your original ECU is copied to another fully functional ECU. The cloned unit is then ready for installation without additional programming.
You must send us your original ECU so that we can transfer its data to the replacement unit.
The original ECU must have working communication with the vehicle, a diagnostic tool or our programming equipment. If the required data cannot be read, a complete 1:1 clone may not be possible.
3. Complete Plug & Play Set
A complete matched set containing the ECU, immobilizer components and all other parts required to start the vehicle without additional programming. All components supplied in the set must be installed in the vehicle.
Important:
Dispatch time depends on the selected option. If an unlocked or specially prepared version is ordered, the preparation service usually requires an additional 1–2 business days.
Ask about the product
ECU Engine controller Alfa Romeo 159 1.9 JTDM 0281013138 55204661
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
120,00 zł
-
shipping
(Poland)
from
120,00 zł
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
Engine Control Unit Alfa Romeo 159 1.9 JTDM 0281013138 55204661
Engine control unit with part numbers 0281013138 and 55204661 intended for Alfa Romeo 159 1.9 JTDM, fully compatible by part number and ready for installation in the vehicle.
FAQ – Engine Control Unit Alfa Romeo 159 1.9 JTDM 0281013138 / 51812906 / 55204661
Does engine control unit 0281013138 fit Alfa Romeo 159 1.9 JTDM?
The engine control unit with numbers 0281013138 and 51812906 is used in Alfa Romeo 159 equipped with the 1.9 JTDM engine. It is responsible for managing engine operation and ensuring its proper performance. In our store, two variants are available: engine control unit in locked or logged-out version – please read the variant description before making a selection.
What do numbers 51812906 and 0281013138 mean on the engine control unit?
Numbers 51812906 and 0281013138 identify a specific engine control unit installed in Alfa Romeo 159 1.9 JTDM. They allow correct matching of the computer to the vehicle. We offer the engine control unit in locked or logged-out version – details are provided in the product description.
Does Alfa Romeo 159 engine control unit 0281013138 require adaptation?
When replacing engine control unit 0281013138 or 51812906, adaptation to the vehicle may be required. The scope depends on the selected variant. The store offers the engine control unit in locked and logged-out versions – please check the description before purchase.
Which engine is engine control unit 55204661 designed for?
The engine control unit marked 55204661, also appearing as 0281013138, is intended for Alfa Romeo 159 with the 1.9 JTDM engine. It is the module controlling engine operation. We offer two variants: locked or logged-out engine control unit – please review the description before choosing.
How to check compatibility of engine control unit 0281013138 with the vehicle?
To confirm compatibility, compare number 0281013138 or 55204661 with the existing engine control unit in your car. Matching numbers confirm proper fitment for Alfa Romeo 159 1.9 JTDM. In our store, two variants are available: engine control unit in locked and logged-out version – details can be found in the product description.
