A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
ABS pump Kia Mobis J758928900 58910J7EB0
Vendors's code: J7589-28900
Product code: A4EC-7191B
Barcode:
Code 39:
ISBN:
€487.80
Price
€487.80
€600.00
Price
€600.00
Ask about the product
ABS pump Kia Mobis J758928900 58910J7EB0
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
€30.00
-
shipping
(Poland)
from
€30.00
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
Will ABS pump J758928900 fit your Kia?
Used original ABS module with number J758928900 for Kia. Confirm compatibility with the number from your original pump.
How to identify ABS pump J758928900 for your Kia
ABS pump J758928900 for Kia is a used original module that regulates brake pressure when a wheel starts to lock up. It is matched by the numbers on its labels, not by the car model alone. The listing does not state the car model or year, so we do not give them here and match the part by its numbers.
Numbers and markings on the ABS pump
The numbers from the listing, as written on the labels and as a single string:
- J7589-28900 (catalogue format: J758928900), original Kia number,
- 58910-J7EB0 (catalogue format: 58910J7EB0), original Kia number.
The full numbers matter, including their endings. If in doubt, send us a photo of your pump.
What can point to an ABS pump failure
- the pump motor switches on at unusual moments or runs louder than usual,
- brake fluid leaks from the hydraulic block, which requires immediate action,
- the ABS warning light comes on together with the stability control warning light,
- the ABS switches itself off shortly after the engine is started.
It is worth reading the fault codes and checking the sensor wiring before replacement. Fitting and bleeding the brake system are usually carried out by a garage with the right equipment.
Questions and answers
| Where do I find number J758928900 on my pump? |
|---|
| The numbers are stamped or printed on the aluminium hydraulic block, and the control unit has a separate sticker. Take a close-up photo of both places in good light. |
| Do the brakes need bleeding after replacing the module? |
| If the brake lines are disconnected during fitting, the system must be bled. The fault codes in the control unit usually need to be cleared as well. |
| Who makes this module? |
| The module is made by Mobis. The manufacturer's name does not change the numbers you should use to match the part. |
| What condition is this pump in? |
| It is a used original part, inspected before sale. You will find the warranty period in the product features table. |
Want to check before you buy? Send a photo of the block and sticker on your ABS pump and we will check that the numbers match.
