A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
ABS pump and control module Opel Insignia 13316697 16817008
Vendors's code: 13316697
Product code: 54085328C
Barcode:
Code 39:
ISBN:
€100.00
Price
€100.00
€100.00
Price
€100.00
In stock
Ask about the product
ABS pump and control module Opel Insignia 13316697 16817008
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
€30.00
-
shipping
(Poland)
from
€30.00
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
How do you choose an ABS pump for the Opel Insignia?
This is a used, working ABS pump with control module for the Opel Insignia - numbers 13316697; 16817008. Before buying, compare the numbers with the label on the module in your car.
ABS pump and control module Opel Insignia
Looking for a replacement for a faulty ABS pump for the Opel Insignia? We offer a used, working unit with electronics in good condition.
Numbers to compare
- 13316697 - part number (OEM)
- 16817008 - part number (OEM)
- 16312208-G - part number (OEM)
- 54085328C - part number (OEM)
Application according to the listing
- Opel Insignia - model
How an ABS pump with control module works
The control module receives signals from the wheel speed sensors and compares them. When one wheel slows down faster than the others, it controls the valves in the hydraulic block to prevent it from locking.
Matching
We also offer other pumps for this model with different numbers. Choose by the number on the module, not by the model alone. The brake system is critical for safety, so fitting is best left to a workshop that will bleed the brakes and check ABS operation.
Symptoms of a faulty ABS pump
- valve fault codes appear,
- the ABS works unevenly,
- the warning light stays on even after a sensor replacement,
- the module stops responding after moisture gets in.
Before buying, make sure the cause is not the power supply or the wiring loom, and only then replace the module.
Questions and answers
| Is the part new? |
|---|
| The pump is used, but in working order. You will find its condition in the product features. |
| Can I fit a pump from a different equipment version? |
| We do not assume so. Modules differ in functions (ABS, ESP, ASR) and software, so compare the numbers and the version of your car. |
| Does the brake fluid need replacing after the pump is fitted? |
| The system has to be bled after the pump is replaced anyway, so it is a good moment to check the fluid and replace it if it is old. |
Send questions about compatibility to contact@auto24parts.com - state the model, year and the number from the module.
