A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
ABS pump and control module Audi Seat Skoda Volkswagen ATE 1J0614117B 10020400524 1J0907379D 10094903003
Vendors's code: 10020400524
Product code: D1CC-28009
Barcode:
Code 39:
ISBN:
325,20 zł
Price
325,20 zł
400,00 zł
Price
400,00 zł
Ask about the product
ABS pump and control module Audi Seat Skoda Volkswagen ATE 1J0614117B 10020400524 1J0907379D 10094903003
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
120,00 zł
-
shipping
(Poland)
from
120,00 zł
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
How do you match ABS pump 1J0614117B to your car?
It all comes down to matching markings: this used, working ATE unit numbered 1J0 614 117 B, paired with control module 1J0 907 379 D, will replace a part with identical numbers in an Audi, Seat, Skoda or Volkswagen.
ATE 1J0614117B - ABS block with module 1J0907379D
This item carries two kinds of markings. The VAG Group numbers - 1J0614117B for the hydraulic unit and 1J0907379D for the control module - are the ones used to order parts for Audi, Seat, Skoda and Volkswagen cars. Alongside them, ATE, the manufacturer of the component, has added its own catalogue numbers: 10.0204-0052.4 for the hydraulic block and 10.0949-0300.3 on the electronic module. The VAG numbers decide the fit, while the ATE numbers help you confirm exactly which version you are dealing with.
How to read the markings on this unit
- 1J0614117B - VAG number of the ABS pump (hydraulic unit), shown on the sticker as 1J0 614 117 B
- 10020400524 - ATE number of the hydraulic block (pump), in the manufacturer's format: 10.0204-0052.4
- 1J0907379D - VAG number of the ABS/ESP control module, on the module label: 1J0 907 379 D
- 10094903003 - ATE number from the control module label, printed as 10.0949-0300.3
The pump markings are printed on a paper sticker attached to the motor housing - in the photo part of the print reflects the light, so if in doubt, ask us for an extra shot. The control module label reads ‘Controller’ and ‘Steuergeraet fuer ABS’. We stock 5 more versions of this pump with a different suffix, so the letter B at the end of 1J0 614 117 B should match your part.
Signs that the ABS unit may be faulty
Trouble with this component most often shows up as:
- the ABS warning light on together with the ESP light,
- ABS not working under hard braking,
- a pump fault stored in the control module.
Before you decide to replace it, read the fault codes and inspect the wheel speed sensors, fuses and wiring connector; measure the battery voltage too, as a voltage drop can trigger similar messages. After fitting, the brake system has to be bled, and on many VW Group cars the module is coded with a diagnostic tool; if the car has ESP, calibration of the steering angle sensor is usually needed as well.
Questions about pump 1J0614117B
| Which cars does this unit fit? |
|---|
| The number 1J0 614 117 B appears on Audi, Seat, Skoda and Volkswagen cars. We do not list models - you choose the part by comparing the pump and control module numbers with those on your car. |
| What condition is the part in? |
| It is a genuine, used and working ATE unit from a dismantled vehicle. The warranty period is given in the product features table. |
| Am I buying just the pump or the control module as well? |
| You get both: the hydraulic block with its motor and the 1J0 907 379 D module bolted to it. |
| What do the numbers 10.0204-0052.4 and 10.0949-0300.3 mean? |
| They are ATE's own numbers: the first identifies the hydraulic block, the second comes from the control module label. They make identification easier when the VAG number is hard to see. |
Not sure? Give us your VIN or attach photos of the sticker on the pump motor and the module label, and we will check compatibility.
Customers Also Viewed
-
Price 400,00 złPrice 325,20 zł
