A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
ABS pump Hyundai Mando 58920D7210
Vendors's code: 58920-D7210
Product code: 306E-599D8
Barcode:
Code 39:
ISBN:
€284.55
Price
€284.55
€350.00
Price
€350.00
Ask about the product
ABS pump Hyundai Mando 58920D7210
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
€30.00
-
shipping
(Poland)
from
€30.00
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
What does number 58920D7210 on an ABS pump mean?
Used ABS pump with control unit, number 58920D7210, inspected before sale. Matched by the numbers on the block and sticker.
Hyundai ABS pump 58920D7210: hydraulic module with control unit
ABS pump 58920D7210 for Hyundai is a used original module that regulates brake pressure when a wheel starts to lock up. It is matched by the numbers on its labels, not by the car model alone. The listing does not state the car model or year, so we do not give them here and match the part by its numbers.
Numbers and markings on the ABS pump
Below are the numbers as they appear on the labels, together with the single-string form used in catalogues:
- 58920-D7210 (catalogue format: 58920D7210), original Hyundai number.
Check the numbers on your pump and compare them with those above. If any of them differs, contact us before ordering.
What ABS problems can point to
- the ABS warning light comes on after the engine is started and stays on,
- the ABS stops working, although basic braking usually remains functional,
- the brake pedal pulses or feels uneven for no obvious reason,
- the ABS switches itself off shortly after the engine is started.
ABS faults should not be ignored, because without anti-lock protection the car brakes less well on wet or slippery roads. Diagnosis and fitting are best left to a garage with a suitable scanner.
Questions and answers
| Does a lit ABS warning light always mean a faulty pump? |
|---|
| No. Read the fault codes first, because the cause may be a wheel sensor, its wiring or too low a supply voltage. |
| Do the brakes need bleeding after replacing the module? |
| If the brake lines are disconnected during fitting, the system must be bled. The fault codes in the control unit usually need to be cleared as well. |
| Who makes this module? |
| The module is made by Mando. The manufacturer's name does not change the numbers you should use to match the part. |
| Is this a new part? |
| No. We sell used original modules, each one inspected before sale. You will find the warranty period in the product features table. |
Not certain this is the right module? Send us the numbers from the label on your pump and we will help you compare them.
