A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
ABS pump and control unit Nissan X-Trail 47660EQ041 4422E0474 17886506
Vendors's code: 47660EQ041
Product code: 47660EQ041
Barcode:
Code 39:
ISBN:
Ask about the product
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
Does ABS pump 47660EQ041 fit the Nissan X-Trail?
Yes, if the number on the module in your car is 47660EQ041. This is a used, fully working ABS pump with control unit for the Nissan X-Trail. You confirm the fit with the number on the sticker.
ABS pump and control unit Nissan X-Trail 47660EQ041 4422E0474 17886506
An ABS pump with control unit is a single module: a hydraulic block with the pump and valves, with the control unit attached to it. This one is intended for the Nissan X-Trail and carries number 47660EQ041. The part is used, fully working and inspected before sale.
Numbers to compare
- 47660EQ041 – part number (OEM), on the sticker 47660 EQ041
- 4422E0474 – additional number from the listing
- 17886506 – additional number from the listing
Compatibility is determined by the number on the sticker, not by the car model alone. X-Trail versions differ in equipment, engine and brake system, so compare all the numbers.
Signs of a faulty ABS pump
- the ABS warning light stays on after the engine starts,
- the pump motor does not start or runs louder than usual,
- an unusual noise when braking,
- brake fluid leaks from the hydraulic unit.
Before buying a pump, check the fuse, power supply, ground and wheel speed sensors – a damaged wiring harness or sensor can cause similar symptoms.
Questions and answers
| Are the pump and the control unit sold separately? |
|---|
| In this listing they are a single module: a hydraulic block with the pump and valves, with the control unit attached to it. |
| Does the brake system need bleeding after replacement? |
| Yes. The system is bled after replacing the pump, so it is a good moment to check the brake fluid and change it if it is old. Fitting is best left to a workshop. |
| Is this a new part? |
| No. We sell used original modules, each one inspected before sale. You will find the warranty period in the product features table. |
Want to check before you buy? Send a photo of the sticker on your ABS pump to contact@auto24parts.com and we will check that the numbers match. See also: ABS pumps for Nissan and complete ABS pumps.