A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
ABS pump BMW ATE 34515A3586701
Vendors's code: 5A35867
Product code: 34515A3586701
Barcode:
Code 39:
ISBN:
€325.20
Price
€325.20
€400.00
Price
€400.00
Ask about the product
ABS pump BMW ATE 34515A3586701
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
€30.00
-
shipping
(Poland)
from
€30.00
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
Will ABS pump 34515A3586701 fit your BMW?
ABS pump 34515A3586701 complete with control unit, used and inspected. Compare the numbers with the original in your car.
BMW ABS pump 34515A3586701: hydraulic module with control unit
ABS module 34515A3586701 is used and has been inspected before sale. It is intended for BMW cars, but whether it fits is decided by comparing the numbers with the original part in your car. The listing does not state the car model or year, so we do not give them here and match the part by its numbers.
Numbers and markings on the ABS pump
The numbers from the listing, as written on the labels and as a single string:
- 3451 5A35867 01 (catalogue format: 34515A3586701), BMW number of the ABS pump (hydraulic part).
Check the numbers on your pump and compare them with those above. If any of them differs, contact us before ordering.
What ABS problems can point to
- the pump motor switches on at unusual moments or runs louder than usual,
- brake fluid leaks from the hydraulic block, which requires immediate action,
- the ABS warning light comes on together with the stability control warning light,
- on a slippery surface the wheels lock up noticeably sooner than they used to.
It is worth reading the fault codes and checking the sensor wiring before replacement. Fitting and bleeding the brake system are usually carried out by a garage with the right equipment.
Questions and answers
| Where do I find number 34515A3586701 on my pump? |
|---|
| The numbers are stamped or printed on the aluminium hydraulic block, and the control unit has a separate sticker. Take a close-up photo of both places in good light. |
| Are the pump and the control unit sold separately? |
| In this listing they are a single module: a hydraulic block with the pump and valves, with the control unit attached to it. |
| Who makes this module? |
| The module is made by ATE. The manufacturer's name does not change the numbers you should use to match the part. |
| Is this a new part? |
| No. We sell used original modules, each one inspected before sale. You will find the warranty period in the product features table. |
Want to check before you buy? Send a photo of the block and sticker on your ABS pump and we will check that the numbers match.
