A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
ABS pump BMW ATE 6862248 6862249
Vendors's code: 6862248
Product code: A244-406E9
Barcode:
Code 39:
ISBN:
€569.11
Price
€569.11
€700.00
Price
€700.00
Ask about the product
ABS pump BMW ATE 6862248 6862249
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
€30.00
-
shipping
(Poland)
from
€30.00
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
Will ABS pump 6862248 fit your BMW?
ABS pump 6862248 complete with control unit, used and inspected. Compare the numbers with the original in your car.
Is ABS pump 6862248 the right part for your BMW?
This module is made by ATE. ABS pump 6862248 is sold together with its control unit, just as it is fitted to BMW cars. The listing does not state the car model or year, so we do not give them here and match the part by its numbers.
Part number 6862248 and related numbers
Below are the numbers as they appear on the labels, together with the single-string form used in catalogues:
- 6862248, BMW number in short form, without the group prefix,
- 6862249, BMW number in short form, without the group prefix.
The full numbers matter, including their endings. If in doubt, send us a photo of your pump.
Symptoms of a faulty ABS pump or control unit
- the ABS warning light comes on after the engine is started and stays on,
- the pump motor switches on at unusual moments or runs louder than usual,
- the ABS activates for no reason during normal braking,
- the ABS switches itself off shortly after the engine is started.
ABS faults should not be ignored, because without anti-lock protection the car brakes less well on wet or slippery roads. Diagnosis and fitting are best left to a garage with a suitable scanner.
Questions and answers
| Where do I find number 6862248 on my pump? |
|---|
| The numbers are stamped or printed on the aluminium hydraulic block, and the control unit has a separate sticker. Take a close-up photo of both places in good light. |
| Does a lit ABS warning light always mean a faulty pump? |
| No. Read the fault codes first, because the cause may be a wheel sensor, its wiring or too low a supply voltage. |
| Who makes this module? |
| The module is made by ATE. The manufacturer's name does not change the numbers you should use to match the part. |
| What condition is this ABS module in? |
| It is an original recycled part in good condition, checked by us. Warranty details are in the product features table. |
Not sure about the match? Send us a photo of the numbers on your ABS pump and we will check whether this module will fit.
