The automatic transmission control unit (often designated as TCU or TCM) is a crucial electronic component responsible for smooth and trouble-free gear shifting. Its failure, most often caused by overheating, short circuits, or water damage, results in jerking, an inability to shift gears, or the vehicle entering limp mode. Purchasing a new module at an authorized dealership is a massive expense, which is why replacing it with a fully functional, used original is the most reasonable solution.
ECU Engine controller VOLKSWAGEN T5 2.5 TDI 0281014252 070906016DS EDC16U31
Vendors's code: 0281014252
Product code: 070906016DS
Barcode:
Code 39:
ISBN:
650,41 zł
Price
650,41 zł
800,00 zł
Price
800,00 zł
Select a product option:
Individual variants may differ in price
product option
Important: Depending on the ECU type and vehicle model, not all of the options listed below may be available.
To select the correct option for your vehicle and ECU, please contact us before purchasing:
contact@auto24parts.com
1. Locked
This option is intended for professional workshops with the required specialist equipment and technical knowledge.
The ECU has been removed from a vehicle intended for recycling and still contains the immobilizer data and other information from the previous vehicle. Before it can be used in another car, it must be unlocked and then programmed using specialist automotive diagnostic equipment.
2. Unlocked
Several preparation methods may be available. The possible options depend on the ECU type, vehicle model and immobilizer system. Please contact us before purchasing, as some preparation methods are not available for every ECU.
Our electronics specialists can prepare the ECU in one of the following ways:
a) ECU with PIN code (Car Pass)
The PIN code is supplied, but programming with a suitable diagnostic tool is still required. After installing the ECU, it must be reset using the supplied PIN code and then programmed to the vehicle’s immobilizer system.
b) VIRGIN ECU
The data from the previous vehicle is removed and the ECU is restored to a clean, factory-like state. After installation, it must be programmed to the vehicle using a compatible specialist diagnostic tool. Unless another preparation method is specified in the product description, this is the standard unlocking option for most of our ECUs.
c) Plug & Play – IMMO OFF
The immobilizer function is disabled in the ECU. After installation, the engine can start without additional immobilizer programming. Please note that the vehicle will no longer have an active immobilizer function, and an immobilizer warning light or fault code may remain, depending on the vehicle model.
d) Plug & Play – Automatic Programming
After installation, the ECU automatically learns and saves the required vehicle data. No additional programming is normally required.
e) Plug & Play – 1:1 Clone
The data from your original ECU is copied to another fully functional ECU. The cloned unit is then ready for installation without additional programming.
You must send us your original ECU so that we can transfer its data to the replacement unit.
The original ECU must have working communication with the vehicle, a diagnostic tool or our programming equipment. If the required data cannot be read, a complete 1:1 clone may not be possible.
3. Complete Plug & Play Set
A complete matched set containing the ECU, immobilizer components and all other parts required to start the vehicle without additional programming. All components supplied in the set must be installed in the vehicle.
Important:
Dispatch time depends on the selected option. If an unlocked or specially prepared version is ordered, the preparation service usually requires an additional 1–2 business days.
Ask about the product
ECU Engine controller VOLKSWAGEN T5 2.5 TDI 0281014252 070906016DS EDC16U31
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
120,00 zł
-
shipping
(Poland)
from
120,00 zł
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
EDC16U31 070906016DS 0281014252 – ECU for VW Transporter T5 2.5 TDI
Original Bosch ECU ENGINE CONTROLLER EDC16U31 for Volkswagen Transporter T5 2.5 TDI, fully tested and verified to ensure reliable operation. Carefully prepared for secure shipping within Europe and worldwide.
Volkswagen T5 2.5 TDI engine controller 0281014252 070906016DS EDC16U31 – FAQ
1. Which models are compatible with the ECU 070906016DS and 0281014252?
The 070906016DS / 0281014252 engine controller is used in selected Volkswagen T5 2.5 TDI diesel versions equipped with the EDC16U31 management system. Before purchase, the numbers from the original ECU should be compared carefully, as matching part numbers are essential for correct vehicle operation.
2. Does the EDC16U31 engine controller require programming after installation?
In most cases, the EDC16U31 Volkswagen T5 controller requires adaptation or transfer of immobiliser data. This applies especially to part numbers 070 906 016 DS and 0 281 014 252. The configuration process depends on the vehicle equipment and ECU software version.
3. What symptoms can a faulty 0281014252 controller cause in a VW T5?
A faulty 0281014252 module may cause starting problems, no diagnostic communication, uneven engine operation or limp mode. In Volkswagen T5 2.5 TDI vehicles, ECU failure may also result in the engine stalling while driving.
4. What makes the 070906016DS engine controller for Volkswagen T5 specific?
The 070906016DS controller is a Bosch unit operating with the EDC16U31 system, used in T5 models with the 2.5 TDI engine. It controls engine operating parameters, fuel injection and communication with the immobiliser and diagnostic systems.
5. What should be checked before buying the ECU 070906016DS?
The most important step is to verify the part numbers: 070906016DS, 0281014252 and the EDC16U31 designation. Even a small difference in the final characters of the number may indicate another software version or incompatibility with the Volkswagen T5 wiring system.
