A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
Engine Control Unit Skoda Felicia 1.6 AEE Magneti Marelli 032906030AG 6160028406
Vendors's code: 6160028406
Product code: 032906030AG
Barcode:
Code 39:
ISBN:
€81.30
Price
€81.30
€100.00
Price
€100.00
Select a product option:
Individual variants may differ in price
product option
Important: Depending on the ECU type and vehicle model, not all of the options listed below may be available.
To select the correct option for your vehicle and ECU, please contact us before purchasing:
contact@auto24parts.com
1. Locked
This option is intended for professional workshops with the required specialist equipment and technical knowledge.
The ECU has been removed from a vehicle intended for recycling and still contains the immobilizer data and other information from the previous vehicle. Before it can be used in another car, it must be unlocked and then programmed using specialist automotive diagnostic equipment.
2. Unlocked
Several preparation methods may be available. The possible options depend on the ECU type, vehicle model and immobilizer system. Please contact us before purchasing, as some preparation methods are not available for every ECU.
Our electronics specialists can prepare the ECU in one of the following ways:
a) ECU with PIN code (Car Pass)
The PIN code is supplied, but programming with a suitable diagnostic tool is still required. After installing the ECU, it must be reset using the supplied PIN code and then programmed to the vehicle’s immobilizer system.
b) VIRGIN ECU
The data from the previous vehicle is removed and the ECU is restored to a clean, factory-like state. After installation, it must be programmed to the vehicle using a compatible specialist diagnostic tool. Unless another preparation method is specified in the product description, this is the standard unlocking option for most of our ECUs.
c) Plug & Play – IMMO OFF
The immobilizer function is disabled in the ECU. After installation, the engine can start without additional immobilizer programming. Please note that the vehicle will no longer have an active immobilizer function, and an immobilizer warning light or fault code may remain, depending on the vehicle model.
d) Plug & Play – Automatic Programming
After installation, the ECU automatically learns and saves the required vehicle data. No additional programming is normally required.
e) Plug & Play – 1:1 Clone
The data from your original ECU is copied to another fully functional ECU. The cloned unit is then ready for installation without additional programming.
You must send us your original ECU so that we can transfer its data to the replacement unit.
The original ECU must have working communication with the vehicle, a diagnostic tool or our programming equipment. If the required data cannot be read, a complete 1:1 clone may not be possible.
3. Complete Plug & Play Set
A complete matched set containing the ECU, immobilizer components and all other parts required to start the vehicle without additional programming. All components supplied in the set must be installed in the vehicle.
Important:
Dispatch time depends on the selected option. If an unlocked or specially prepared version is ordered, the preparation service usually requires an additional 1–2 business days.
Ask about the product
Engine Control Unit Skoda Felicia 1.6 AEE Magneti Marelli 032906030AG 6160028406
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
€30.00
-
shipping
(Poland)
from
€30.00
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
Where can you find the number 032906030AG on a Felicia ECU?
The VW number and the Magneti Marelli number 61600.284.06 are on the label on the unit's casing. This used, fully working ECU comes from a Felicia 1.6 with the AEE engine.
Engine Control Unit Skoda Felicia 1.6 AEE Magneti Marelli 032906030AG 6160028406
The 1.6 AEE petrol engine in a Skoda Felicia – that is the kind of car this Magneti Marelli ECU, number 032906030AG, was removed from. In the manufacturer's numbering it is designated 6160028406. The unit controls fuel injection and ignition, and if it fails, the car can be immobilised completely.
Numbers on the sticker
- 032906030AG – VW/Skoda part number
- 6160028406 – Magneti Marelli number, as on the label 61600.284.06
The dotted format is standard Magneti Marelli numbering. The AG suffix in the VW number identifies the software or hardware version – compare it carefully.
Signs of ECU damage
- no spark or no injection, although the starter cranks normally,
- jerking and hesitation when accelerating,
- no communication via the diagnostic socket,
- signs of moisture or corrosion on the connector and casing.
A faulty engine speed sensor or a chafed wire produces similar symptoms, so check those first.
Locked or unlocked – which to choose?
First decide who will fit the unit. Garages that will unlock, program and adapt it to the car themselves usually take the locked version – with the donor car's data and immobiliser. For everyone else, we recommend the unlocked version, which we prepare in-house before dispatch (normally 1–2 working days).
Possible methods include PIN / CAR PASS, Virgin, IMMO OFF, auto programming and cloning, but not all of them will necessarily be available for 032906030AG – it depends on the part number, software and immobiliser. Please contact us before you buy and have a look at the page on ECU options.
Questions and answers
| Can a Felicia 1.6 AEE have a Siemens ECU instead of a Magneti Marelli one? |
|---|
| Yes, units from both manufacturers are found on this engine. Replace it with an ECU with the same number – here 032906030AG. |
| Will ECU 032906030AG start the engine straight after fitting? |
| The locked version will not – it has to be unlocked and matched to the immobiliser. With the unlocked version, it depends on the preparation method agreed before purchase. |
| How long does it take to prepare the unlocked version? |
| Usually 1–2 working days before dispatch. We confirm the method beforehand, as it depends on the part number, software and immobiliser. |
| What condition is this ECU in? |
| It is a used part, fully working and in good condition. You will find the warranty period in the product specification table. |
Have a question about compatibility? Email contact@auto24parts.com with a photo of your ECU's label.
