A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
Engine Control Unit Skoda Octavia 2.0 FSI Bosch MED9.5.10 06F906056ER 0261S02260
Vendors's code: 0261S02260
Product code: 0261S02260
Barcode:
Code 39:
ISBN:
$245.89
Price
$245.89
$302.45
Price
$302.45
Select a product option:
Individual variants may differ in price
product option
Important: Depending on the ECU type and vehicle model, not all of the options listed below may be available.
To select the correct option for your vehicle and ECU, please contact us before purchasing:
contact@auto24parts.com
1. Locked
This option is intended for professional workshops with the required specialist equipment and technical knowledge.
The ECU has been removed from a vehicle intended for recycling and still contains the immobilizer data and other information from the previous vehicle. Before it can be used in another car, it must be unlocked and then programmed using specialist automotive diagnostic equipment.
2. Unlocked
Several preparation methods may be available. The possible options depend on the ECU type, vehicle model and immobilizer system. Please contact us before purchasing, as some preparation methods are not available for every ECU.
Our electronics specialists can prepare the ECU in one of the following ways:
a) ECU with PIN code (Car Pass)
The PIN code is supplied, but programming with a suitable diagnostic tool is still required. After installing the ECU, it must be reset using the supplied PIN code and then programmed to the vehicle’s immobilizer system.
b) VIRGIN ECU
The data from the previous vehicle is removed and the ECU is restored to a clean, factory-like state. After installation, it must be programmed to the vehicle using a compatible specialist diagnostic tool. Unless another preparation method is specified in the product description, this is the standard unlocking option for most of our ECUs.
c) Plug & Play – IMMO OFF
The immobilizer function is disabled in the ECU. After installation, the engine can start without additional immobilizer programming. Please note that the vehicle will no longer have an active immobilizer function, and an immobilizer warning light or fault code may remain, depending on the vehicle model.
d) Plug & Play – Automatic Programming
After installation, the ECU automatically learns and saves the required vehicle data. No additional programming is normally required.
e) Plug & Play – 1:1 Clone
The data from your original ECU is copied to another fully functional ECU. The cloned unit is then ready for installation without additional programming.
You must send us your original ECU so that we can transfer its data to the replacement unit.
The original ECU must have working communication with the vehicle, a diagnostic tool or our programming equipment. If the required data cannot be read, a complete 1:1 clone may not be possible.
3. Complete Plug & Play Set
A complete matched set containing the ECU, immobilizer components and all other parts required to start the vehicle without additional programming. All components supplied in the set must be installed in the vehicle.
Important:
Dispatch time depends on the selected option. If an unlocked or specially prepared version is ordered, the preparation service usually requires an additional 1–2 business days.
Ask about the product
Engine Control Unit Skoda Octavia 2.0 FSI Bosch MED9.5.10 06F906056ER 0261S02260
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
$30.24
-
shipping
(Poland)
from
$30.24
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
Looking for a 06F906056ER ECU for an Octavia 2.0 FSI?
This Bosch MED9.5.10 unit has VW number 06F906056ER and Bosch number 0 261 S02 260. It is used, fully working and comes from a petrol Octavia 2.0 FSI; we will send it locked or unlocked.
Engine Control Unit Skoda Octavia 2.0 FSI Bosch MED9.5.10 06F906056ER 0261S02260
The petrol Octavia 2.0 FSI has a direct-injection engine, and this unit, 06F906056ER, is a Bosch MED9.5.10 – a Motronic ECU for petrol direct-injection engines. It manages the fuel quantity, ignition and throttle body. It is used, fully working and in good condition.
How to identify this ECU
- 06F906056ER – VW/Skoda part number
- 0261S02260 – Bosch number; as shown on the label: 0 261 S02 260
- MED9.5.10 – Bosch ECU type
The letters "ER" at the end of the VW number denote the software or hardware version. A unit with a different suffix may have different software – when replacing, what counts is the exact number 06F906056ER.
Symptoms that may point to the ECU
- no start although the starter and fuel system are working,
- limp mode with reduced power that appears for no reason,
- no communication with the unit on the tester,
- faults in several circuits at once, e.g. injectors and coils.
Before replacing it, check the power supply, earths and wiring loom – a wiring fault can look just like a failed unit.
Unlocking: by us or at your garage
In the locked version, the ECU retains the data and immobiliser from the donor car. Choose it if your garage will carry out the unlocking, programming and adaptation itself.
In the unlocked version, we do the preparation before dispatch – usually within 1–2 working days. Bear in mind that the part number, software and immobiliser determine whether PIN / CAR PASS, Virgin, IMMO OFF, auto-programming or clone is possible, so please ask about this before you buy. All options: engine control unit variants.
Questions and answers
| Does the 06F906056ER ECU fit an Octavia 1.6 FSI? |
|---|
| Do not assume so – this unit comes from an Octavia 2.0 FSI, and the number on the label decides compatibility. |
| How long does it take to prepare the unlocked version? |
| Usually 1–2 working days before dispatch. |
| What condition is the ECU in? |
| Used, fully working, in good condition. You will find the warranty period in the product specifications table. |
Email contact@auto24parts.com with the numbers from your ECU – we will tell you whether this unit is suitable.
