A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
Engine Control Unit Skoda Octavia 1.9 TDI ASV Bosch 038906012BA 0281010130
Vendors's code: 0281010130
Product code: 0281010130
Barcode:
Code 39:
ISBN:
325,20 zł
Price
325,20 zł
400,00 zł
Price
400,00 zł
Select a product option:
Individual variants may differ in price
product option
Important: Depending on the ECU type and vehicle model, not all of the options listed below may be available.
To select the correct option for your vehicle and ECU, please contact us before purchasing:
contact@auto24parts.com
1. Locked
This option is intended for professional workshops with the required specialist equipment and technical knowledge.
The ECU has been removed from a vehicle intended for recycling and still contains the immobilizer data and other information from the previous vehicle. Before it can be used in another car, it must be unlocked and then programmed using specialist automotive diagnostic equipment.
2. Unlocked
Several preparation methods may be available. The possible options depend on the ECU type, vehicle model and immobilizer system. Please contact us before purchasing, as some preparation methods are not available for every ECU.
Our electronics specialists can prepare the ECU in one of the following ways:
a) ECU with PIN code (Car Pass)
The PIN code is supplied, but programming with a suitable diagnostic tool is still required. After installing the ECU, it must be reset using the supplied PIN code and then programmed to the vehicle’s immobilizer system.
b) VIRGIN ECU
The data from the previous vehicle is removed and the ECU is restored to a clean, factory-like state. After installation, it must be programmed to the vehicle using a compatible specialist diagnostic tool. Unless another preparation method is specified in the product description, this is the standard unlocking option for most of our ECUs.
c) Plug & Play – IMMO OFF
The immobilizer function is disabled in the ECU. After installation, the engine can start without additional immobilizer programming. Please note that the vehicle will no longer have an active immobilizer function, and an immobilizer warning light or fault code may remain, depending on the vehicle model.
d) Plug & Play – Automatic Programming
After installation, the ECU automatically learns and saves the required vehicle data. No additional programming is normally required.
e) Plug & Play – 1:1 Clone
The data from your original ECU is copied to another fully functional ECU. The cloned unit is then ready for installation without additional programming.
You must send us your original ECU so that we can transfer its data to the replacement unit.
The original ECU must have working communication with the vehicle, a diagnostic tool or our programming equipment. If the required data cannot be read, a complete 1:1 clone may not be possible.
3. Complete Plug & Play Set
A complete matched set containing the ECU, immobilizer components and all other parts required to start the vehicle without additional programming. All components supplied in the set must be installed in the vehicle.
Important:
Dispatch time depends on the selected option. If an unlocked or specially prepared version is ordered, the preparation service usually requires an additional 1–2 business days.
Ask about the product
Engine Control Unit Skoda Octavia 1.9 TDI ASV Bosch 038906012BA 0281010130
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
120,00 zł
-
shipping
(Poland)
from
120,00 zł
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
Looking for a 038906012BA ECU for an Octavia 1.9 TDI ASV?
This used, fully working Bosch unit (0 281 010 130) with VW number 038906012BA comes from a Skoda Octavia with the 1.9 TDI engine, engine code ASV. Available locked or unlocked.
Engine Control Unit Skoda Octavia 1.9 TDI ASV Bosch 038906012BA 0281010130
In the Octavia, engine code ASV denotes the 1.9 TDI – and this ECU comes from exactly such a car. It was made by Bosch, which gave it the number 0281010130, while VW/Skoda assigned it the number 038906012BA. The unit manages fuel injection in the diesel engine.
How to identify this ECU
- 038906012BA – VW/Skoda part number
- 0281010130 – Bosch number, shown on the label as 0 281 010 130
- ASV – engine code of the car the unit came from
Check the engine code and the full VW number. The letters BA at the end of 038906012BA indicate the hardware or software version and matter when matching.
Most common fault symptoms
- the engine will not start or runs only briefly,
- power is restricted for no apparent reason,
- the diagnostic tool cannot see the engine control unit,
- a fault after a voltage surge, e.g. from an incorrect jump start.
It is worth starting with the engine earth points and the condition of the ECU plug – oxidised contacts can cause exactly the same symptoms.
Locked or ready to fit?
The locked option reaches you exactly as it was removed: with the software and immobiliser data of the previous car. It is chosen by workshops that carry out the unlocking, programming and adaptation in-house. The unlocked option is prepared by us before dispatch – this usually takes 1–2 working days.
Possible methods include PIN / CAR PASS, Virgin, IMMO OFF, auto programming or a clone of your own ECU, but their availability depends on the number 038906012BA, the software version and the immobiliser in your car. Ask us about the options before you order. All options are described on the ECU preparation options page.
Questions and answers
| Does it fit every Octavia 1.9 TDI? |
|---|
| No – the Octavia 1.9 TDI had various ECUs. This one has the number 038906012BA and comes from an ASV engine. |
| Where can I find the engine code? |
| Usually on the vehicle identification plate or the vehicle data sticker; the ECU number is on its casing. |
| Is this part new or used? |
| Used – fully working and in good condition. You will find the warranty period in the product specification table. |
Not sure which option to choose? Email contact@auto24parts.com with the numbers from the label and we will advise you.
