A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
Engine Control Unit Volkswagen, Skoda Bosch EDC17C74 04L907309P 0281031483
Vendors's code: 0281031483
Product code: 0281031483
Barcode:
Code 39:
ISBN:
Select a product option:
Individual variants may differ in price
product option
Important: Depending on the ECU type and vehicle model, not all of the options listed below may be available.
To select the correct option for your vehicle and ECU, please contact us before purchasing:
contact@auto24parts.com
1. Locked
This option is intended for professional workshops with the required specialist equipment and technical knowledge.
The ECU has been removed from a vehicle intended for recycling and still contains the immobilizer data and other information from the previous vehicle. Before it can be used in another car, it must be unlocked and then programmed using specialist automotive diagnostic equipment.
2. Unlocked
Several preparation methods may be available. The possible options depend on the ECU type, vehicle model and immobilizer system. Please contact us before purchasing, as some preparation methods are not available for every ECU.
Our electronics specialists can prepare the ECU in one of the following ways:
a) ECU with PIN code (Car Pass)
The PIN code is supplied, but programming with a suitable diagnostic tool is still required. After installing the ECU, it must be reset using the supplied PIN code and then programmed to the vehicle’s immobilizer system.
b) VIRGIN ECU
The data from the previous vehicle is removed and the ECU is restored to a clean, factory-like state. After installation, it must be programmed to the vehicle using a compatible specialist diagnostic tool. Unless another preparation method is specified in the product description, this is the standard unlocking option for most of our ECUs.
c) Plug & Play – IMMO OFF
The immobilizer function is disabled in the ECU. After installation, the engine can start without additional immobilizer programming. Please note that the vehicle will no longer have an active immobilizer function, and an immobilizer warning light or fault code may remain, depending on the vehicle model.
d) Plug & Play – Automatic Programming
After installation, the ECU automatically learns and saves the required vehicle data. No additional programming is normally required.
e) Plug & Play – 1:1 Clone
The data from your original ECU is copied to another fully functional ECU. The cloned unit is then ready for installation without additional programming.
You must send us your original ECU so that we can transfer its data to the replacement unit.
The original ECU must have working communication with the vehicle, a diagnostic tool or our programming equipment. If the required data cannot be read, a complete 1:1 clone may not be possible.
3. Complete Plug & Play Set
A complete matched set containing the ECU, immobilizer components and all other parts required to start the vehicle without additional programming. All components supplied in the set must be installed in the vehicle.
Important:
Dispatch time depends on the selected option. If an unlocked or specially prepared version is ordered, the preparation service usually requires an additional 1–2 business days.
Ask about the product
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
Does ECU 04L907309P fit your Volkswagen or Skoda?
Yes, if your vehicle was fitted with an ECU with VW number 04L907309P and Bosch number 0281031483 (0 281 031 483 on the label). This is a used, working Bosch EDC17C74 module for a diesel engine.
Engine Control Unit Volkswagen, Skoda Bosch EDC17C74 04L907309P 0281031483
The Bosch EDC17C74 ECU with number 04L907309P manages the diesel engine in Volkswagen and Skoda vehicles. It continuously analyses data from the sensors and uses it to set the injection and turbo boost parameters. As our records do not specify a particular model or engine, compatibility is decided solely by the numbers on the label.
How to identify this ECU
- 04L907309P – Volkswagen part number
- 0281031483 – Bosch number, as printed on the sticker 0 281 031 483
- EDC17C74 – Bosch Electronic Diesel Control ECU family
The final letter P in the VW number denotes the software and hardware version. A 04L907309 module with a different letter may have different software, so compare the full number.
Symptoms pointing to the ECU
- the vehicle will not start, although the starter motor and fuel supply work,
- no communication with the engine ECU during diagnostics,
- persistent power reduction with no sensor fault,
- a fault after a voltage spike, short circuit or water ingress.
Before buying an ECU, check the voltage, earths and connector – faults there produce similar symptoms.
Prepared by us or in a workshop
You can order the module unlocked – we prepare it before dispatch, usually within 1–2 working days – or locked, with the data and immobiliser of the previous vehicle stored in it. The latter version is chosen by workshops that unlock, program and match ECUs themselves.
For this number and software, not every method (PIN / CAR PASS, Virgin, IMMO OFF, auto programming, cloning) is necessarily available; the immobiliser in the vehicle also matters. Please ask before buying. More: ECU preparation options.
Questions and answers
| Which model does this ECU fit? |
|---|
| Number 04L907309P is what decides – if your module has the same number, the ECU fits. |
| What should I prepare before ordering the unlocked version? |
| A photo of the label on your current ECU and the VIN. |
| What condition is the module in? |
| Used, in working order and in good condition. You will find the warranty period in the product features table. |
Email contact@auto24parts.com – we will check which options are available for your vehicle.