A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
Engine Control Unit Volkswagen, Skoda 1.4 TDI Delphi DCM6.2V 04B907445 28459901
Vendors's code: 28459901
Product code: 28459901
Barcode:
Code 39:
ISBN:
Select a product option:
Individual variants may differ in price
product option
Important: Depending on the ECU type and vehicle model, not all of the options listed below may be available.
To select the correct option for your vehicle and ECU, please contact us before purchasing:
contact@auto24parts.com
1. Locked
This option is intended for professional workshops with the required specialist equipment and technical knowledge.
The ECU has been removed from a vehicle intended for recycling and still contains the immobilizer data and other information from the previous vehicle. Before it can be used in another car, it must be unlocked and then programmed using specialist automotive diagnostic equipment.
2. Unlocked
Several preparation methods may be available. The possible options depend on the ECU type, vehicle model and immobilizer system. Please contact us before purchasing, as some preparation methods are not available for every ECU.
Our electronics specialists can prepare the ECU in one of the following ways:
a) ECU with PIN code (Car Pass)
The PIN code is supplied, but programming with a suitable diagnostic tool is still required. After installing the ECU, it must be reset using the supplied PIN code and then programmed to the vehicle’s immobilizer system.
b) VIRGIN ECU
The data from the previous vehicle is removed and the ECU is restored to a clean, factory-like state. After installation, it must be programmed to the vehicle using a compatible specialist diagnostic tool. Unless another preparation method is specified in the product description, this is the standard unlocking option for most of our ECUs.
c) Plug & Play – IMMO OFF
The immobilizer function is disabled in the ECU. After installation, the engine can start without additional immobilizer programming. Please note that the vehicle will no longer have an active immobilizer function, and an immobilizer warning light or fault code may remain, depending on the vehicle model.
d) Plug & Play – Automatic Programming
After installation, the ECU automatically learns and saves the required vehicle data. No additional programming is normally required.
e) Plug & Play – 1:1 Clone
The data from your original ECU is copied to another fully functional ECU. The cloned unit is then ready for installation without additional programming.
You must send us your original ECU so that we can transfer its data to the replacement unit.
The original ECU must have working communication with the vehicle, a diagnostic tool or our programming equipment. If the required data cannot be read, a complete 1:1 clone may not be possible.
3. Complete Plug & Play Set
A complete matched set containing the ECU, immobilizer components and all other parts required to start the vehicle without additional programming. All components supplied in the set must be installed in the vehicle.
Important:
Dispatch time depends on the selected option. If an unlocked or specially prepared version is ordered, the preparation service usually requires an additional 1–2 business days.
Ask about the product
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
Looking for ECU 04B907445 with Delphi number 28459901?
We are offering a used, working Delphi DCM6.2V engine ECU from a Volkswagen or Skoda 1.4 TDI. Its label shows VW number 04B907445 and Delphi number 28459901; you can choose the locked or IMMO OFF version.
Engine Control Unit Volkswagen, Skoda 1.4 TDI Delphi DCM6.2V 04B907445 28459901
Delphi 28459901 is the manufacturer number that distinguishes this ECU from other modules marked by Volkswagen as 04B907445. The unit comes from a 1.4 TDI engine in a Volkswagen or Skoda and belongs to the DCM6.2V family – Delphi's diesel ECUs. It controls injection, turbo boost and starting. The IMMO OFF option avoids having to match the module to the immobiliser, provided it suits the specific vehicle.
How to identify this module
- 04B907445 – VW part number – shared by several versions
- 28459901 – Delphi number of this unit
- DCM6.2V – Delphi ECU type
As the VW number does not end with a version letter, the Delphi number is also needed to determine compatibility. If both match, you can be sure we are talking about the same module.
Symptoms of failure
- the 1.4 TDI turns over but will not fire up,
- the tester reports no response from the engine ECU,
- reduced power with no faults in the engine ancillaries,
- the engine cutting out intermittently after moisture has got into the module.
First check the earths, fuses and the module plug.
Locked or IMMO OFF
You choose one of two options. IMMO OFF means that before dispatch we will prepare the ECU with the immobiliser function disabled in the software – before accepting the order, we will confirm whether this solution suits your vehicle. A locked module keeps the data and immobiliser of the previous car and goes to workshops that will program and match it themselves.
We do not offer any other form of unlocked version for this unit. Full description of the options: ECU preparation options.
Questions and answers
| Is this ECU available unlocked? |
|---|
| No. You can choose the locked version or IMMO OFF. |
| How do I know that IMMO OFF suits my vehicle? |
| We will confirm this before purchase based on the numbers and the vehicle details. |
| What condition is ECU 04B907445 in? |
| Used, in working order and in good condition. You will find the warranty period in the product features table. |
Any questions? Email contact@auto24parts.com and include both numbers from the label.