A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
ABS pump Hyundai Mando BH60161A03 500E6030
Vendors's code: BH60161A03
Product code: C63C-636EF
Barcode:
Code 39:
ISBN:
€487.80
Price
€487.80
€600.00
Price
€600.00
Ask about the product
ABS pump Hyundai Mando BH60161A03 500E6030
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
€30.00
-
shipping
(Poland)
from
€30.00
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
Does ABS pump BH60161A03 come complete with the control unit?
ABS pump BH60161A03 complete with control unit, used and inspected. Compare the numbers with the original in your car.
Hyundai ABS pump: numbers BH60161A03 and 500E6030
If the ABS warning light is on in your Hyundai, one possible cause is the hydraulic module or its control unit. ABS pump BH60161A03 is a used original part, inspected before sale. The listing does not state the car model or year, so we do not give them here and match the part by its numbers.
Numbers to compare
The numbers from the listing, as written on the labels and as a single string:
- BH60161A03, additional number from the listing,
- 500-E6030 (catalogue format: 500E6030), additional number from the listing.
Check the numbers on your pump and compare them with those above. If any of them differs, contact us before ordering.
When an ABS module needs replacing
- the brake pedal pulses or feels uneven for no obvious reason,
- valve or pump motor faults are stored in the control unit memory,
- the pump motor switches on at unusual moments or runs louder than usual,
- brake fluid leaks from the hydraulic block, which requires immediate action.
First check the wheel sensors, their wiring and the supply voltage. Only a fault code pointing to the module justifies replacing the pump. After fitting, clear the fault codes and, if necessary, bleed the brake system.
Questions and answers
| Does a lit ABS warning light always mean a faulty pump? |
|---|
| No. Read the fault codes first, because the cause may be a wheel sensor, its wiring or too low a supply voltage. |
| Can I send a photo for a compatibility check? |
| Yes. Contact us and send a photo of the numbers on your original pump, and we will help you check whether this module will fit. |
| Who makes this module? |
| The module is made by Mando. The manufacturer's name does not change the numbers you should use to match the part. |
| What condition is this ABS module in? |
| It is an original recycled part in good condition, checked by us. Warranty details are in the product features table. |
Not certain this is the right module? Send us the numbers from the label on your pump and we will help you compare them.
