A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
Airbag clock spring Opel Vectra C Signum 13132473 CK
Vendors's code: 13132473CK
Product code: 13132473CK
Barcode:
Code 39:
ISBN:
Ask about the product
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
Does airbag clock spring 13132473 CK fit your Opel Vectra C?
We offer a used airbag clock spring 13132473 CK for the Opel Vectra C and Opel Signum. The number on the housing decides the fit, so check it before you order.
Airbag clock spring Opel Vectra C Signum 13132473 CK
We sell a used airbag clock spring with number 13132473 CK. According to the listing it fits the Opel Vectra C and Opel Signum. In the Vectra C and Signum the clock spring is part of the module under the steering wheel, and versions differ by the letter code next to the GM number.
Numbers on the label
- 13132473 CK / 13132473CK - OEM number (GM)
Models in the listing
- Opel Vectra C
- Opel Signum
Inside the housing there is a conductive ribbon wound like a spring. It carries the signal to the driver airbag and from the wheel buttons while the wheel turns.
Typical fault symptoms
- the airbag warning light comes on, often after turning the wheel,
- the horn does not work,
- the airbag module stores a driver airbag circuit fault.
Before fitting
Before work, disconnect the battery and wait the time specified by the car maker. Set the wheels straight and fit the clock spring in its centre position, using the marks on the housing. The clock spring is fitted with the wheels pointing straight ahead and in the centre position. If it is set wrongly, it can tear at the first full turn.
Customer questions
| Will the airbag light go out after replacement? |
|---|
| If the clock spring was the cause, usually yes, but a stored fault sometimes has to be cleared with a diagnostic tool. |
| Does the clock spring need centring before fitting? |
| Yes. It is fitted in the centre position with the wheels pointing straight ahead. |
| Can I send a photo of my part? |
| Yes, send a photo of the label to contact@auto24parts.com and we will check the fit. |
We are happy to help: contact@auto24parts.com. Include your car model and a photo of your clock spring.