A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
Automatic gearbox control unit VW Volkswagen Polo Lupo Bosch 0260002537 001927749G
Vendors's code: 0260002537
Product code: D5F6-613CE
Barcode:
Code 39:
ISBN:
Ask about the product
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
Gearbox control unit with number 0260002537 - is it the right part?
This is a used, working automatic gearbox control unit for the VW Volkswagen Polo Lupo - numbers 0 260 002 537 / 0260002537; 001 927 749 G / 001927749G. Before buying, compare the numbers with the label on the unit in your car.
Automatic gearbox control unit VW Volkswagen Polo Lupo
This listing is for a used, working gearbox control unit for the VW Volkswagen Polo Lupo, engine 1.4, year 1998. The part is in good condition.
Numbers to compare
- 0 260 002 537 / 0260002537 - Bosch number
- 001 927 749 G / 001927749G - VAG number (OEM)
Fitment
The number 0 260 002 429 also appears in another listing. Compare all numbers with the label on your unit - we do not assume listings are interchangeable.
Signs of a faulty gearbox control unit
- gear changes are jerky,
- the gearbox does not change gear or does so with a delay,
- diagnostics point to the gearbox control unit,
- the car enters limp mode and stays in one gear.
Reading the fault codes with a diagnostic tool helps tell a control unit fault from a failure of sensors, solenoid valves or the gearbox itself.
Questions and answers
| Where can I find the number on the control unit? |
|---|
| The number is on the label or housing of the unit once it has been removed from the car. If you cannot read it, send us a photo. |
| What should I check on delivery? |
| Check that the numbers on the unit match the description and that the connector and housing show no visible damage. |
| What does "used, working" mean? |
| We sell it as a used part, working and in good condition, with a 6-month warranty. |
Write to contact@auto24parts.com with the model, year and the number on your unit - we will check the fit.