A faulty transmission control module (TCM) most often causes limp mode with the gearbox stuck in one gear, harsh jolts when you select D or R, erratic gear changes, flashing PRND letters and a gearbox or engine warning light. However, the same symptoms are often caused by a low gearbox oil level, a weak battery, a poor earth or a faulty sensor. To test a transmission control module, start by checking the battery and reading the fault codes with a diagnostic tool that can talk to the gearbox control unit, then check the power supply, the connector, the oil and the live data. Below we explain the symptoms, the diagnostic steps and what the most common fault codes mean.
Engine Control Unit Volkswagen Skoda Audi 1.9 TDI Bosch 038906019PB 0281012920
Vendors's code: 0281012920
Product code: 0281012920
Barcode:
Code 39:
ISBN:
Ask about the product
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
Looking for ECU 038906019PB for a 1.9 TDI Volkswagen, Skoda or Audi?
This Bosch module with VW number 038906019PB and Bosch number 0281012920 (0 281 012 920) comes from a 1.9 TDI engine. It is used and in working order, and we sell it locked or unlocked.
Engine Control Unit Volkswagen, Skoda, Audi 1.9 TDI Bosch 038906019PB 0281012920
The 1.9 TDI engine was fitted to Volkswagen, Skoda and Audi vehicles, and this ECU – 038906019PB – comes from just such an engine. It was made by Bosch; number 0281012920 from the 0 281 series indicates a diesel ECU. The module regulates the fuel quantity, injection timing and boost pressure.
Numbers to compare
- 038906019PB – Volkswagen / Skoda / Audi part number
- 0281012920 – Bosch number, on the label 0 281 012 920
The letters PB at the end of the number are the software and hardware version. There are many variants of 038906019 ECUs, so a match of the whole number matters a great deal here.
When to suspect the engine ECU
- the 1.9 TDI will not start despite a good power supply,
- no response from the module in the diagnostic tester,
- running in limp mode with noticeably weaker acceleration,
- failure after moisture has got into the ECU.
Start by checking the earth leads, fuses and the ECU connector. It is also worth reading the fault codes to distinguish a module fault from a sensor problem.
Options: locked and unlocked
A locked ECU contains the data and immobiliser of the vehicle it came from – it is intended for workshops that will carry out the unlocking, programming and matching themselves. If you choose the unlocked version, we will prepare the module before dispatch, usually within 1–2 working days.
Due to differences in numbers, software and immobilisers, not every preparation method – PIN / CAR PASS, Virgin, IMMO OFF, auto programming or cloning – will be possible. Please ask before buying. Description: ECU preparation options.
Questions and answers
| Does this ECU fit an Audi 1.9 TDI? |
|---|
| Yes, if the Audi was factory-fitted with module 038906019PB – check the label. |
| Can an ECU with a suffix other than PB be fitted? |
| We do not recommend it, as the letter denotes a different software or hardware version. |
| What condition is the ECU in? |
| Used, in working order and in good condition. You will find the warranty period in the product features table. |
If you have any doubts about the number, email contact@auto24parts.com.