The automatic transmission control unit (often designated as TCU or TCM) is a crucial electronic component responsible for smooth and trouble-free gear shifting. Its failure, most often caused by overheating, short circuits, or water damage, results in jerking, an inability to shift gears, or the vehicle entering limp mode. Purchasing a new module at an authorized dealership is a massive expense, which is why replacing it with a fully functional, used original is the most reasonable solution.
ECU Engine controller VOLKSWAGEN SEAT IBIZA 1.9 TDI BOSCH 0281011823 038906019NJ EDC15P+
Vendors's code: 038906019NJ
Product code: 0281011823
Barcode:
Code 39:
ISBN:
€142.28
Price
€142.28
€175.00
Price
€175.00
Select a product option:
Individual variants may differ in price
product option
Important: Depending on the ECU type and vehicle model, not all of the options listed below may be available.
To select the correct option for your vehicle and ECU, please contact us before purchasing:
contact@auto24parts.com
1. Locked
This option is intended for professional workshops with the required specialist equipment and technical knowledge.
The ECU has been removed from a vehicle intended for recycling and still contains the immobilizer data and other information from the previous vehicle. Before it can be used in another car, it must be unlocked and then programmed using specialist automotive diagnostic equipment.
2. Unlocked
Several preparation methods may be available. The possible options depend on the ECU type, vehicle model and immobilizer system. Please contact us before purchasing, as some preparation methods are not available for every ECU.
Our electronics specialists can prepare the ECU in one of the following ways:
a) ECU with PIN code (Car Pass)
The PIN code is supplied, but programming with a suitable diagnostic tool is still required. After installing the ECU, it must be reset using the supplied PIN code and then programmed to the vehicle’s immobilizer system.
b) VIRGIN ECU
The data from the previous vehicle is removed and the ECU is restored to a clean, factory-like state. After installation, it must be programmed to the vehicle using a compatible specialist diagnostic tool. Unless another preparation method is specified in the product description, this is the standard unlocking option for most of our ECUs.
c) Plug & Play – IMMO OFF
The immobilizer function is disabled in the ECU. After installation, the engine can start without additional immobilizer programming. Please note that the vehicle will no longer have an active immobilizer function, and an immobilizer warning light or fault code may remain, depending on the vehicle model.
d) Plug & Play – Automatic Programming
After installation, the ECU automatically learns and saves the required vehicle data. No additional programming is normally required.
e) Plug & Play – 1:1 Clone
The data from your original ECU is copied to another fully functional ECU. The cloned unit is then ready for installation without additional programming.
You must send us your original ECU so that we can transfer its data to the replacement unit.
The original ECU must have working communication with the vehicle, a diagnostic tool or our programming equipment. If the required data cannot be read, a complete 1:1 clone may not be possible.
3. Complete Plug & Play Set
A complete matched set containing the ECU, immobilizer components and all other parts required to start the vehicle without additional programming. All components supplied in the set must be installed in the vehicle.
Important:
Dispatch time depends on the selected option. If an unlocked or specially prepared version is ordered, the preparation service usually requires an additional 1–2 business days.
Ask about the product
ECU Engine controller VOLKSWAGEN SEAT IBIZA 1.9 TDI BOSCH 0281011823 038906019NJ EDC15P+
Administratorem danych osobowych jest Auto24parts. Przetwarzamy je w celu przesłania odpowiedzi na zapytanie. Więcej informacji dotyczących przetwarzania danych osobowych znajduje się w polityce prywatności.
Shipping
from
€30.00
-
shipping
(Poland)
from
€30.00
-
shipping
(Poland)
Price 30 euros applies shipments to 5 kg on worldwide. Above this weight, please contact us by email to check price
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
ECU ENGINE CONTROLLER VOLKSWAGEN SEAT IBIZA 1.9 TDI BOSCH 0281011823 038906019NJ EDC15P+
Tested ECU Engine controller for Volkswagen / Seat Ibiza 1.9 TDI (part numbers 0281011823 and 038906019NJ, Bosch EDC15P+), with warranty and fast shipping.
ECU Engine controller VOLKSWAGEN SEAT IBIZA 1.9 TDI BOSCH 0281011823 038906019NJ EDC15P+
Which vehicles does the ECU Engine controller 0281011823 038906019NJ fit for Volkswagen / Seat Ibiza?
The ECU Engine controller VOLKSWAGEN SEAT IBIZA 1.9 TDI BOSCH 0281011823 038906019NJ EDC15P+ is found on selected 1.9 TDI applications, including Seat Ibiza versions. It manages engine operation and works together with the vehicle’s electronics in everyday driving.
The safest way to confirm compatibility is to match the exact numbers on your original unit: 0281011823 and 038906019NJ (the same references may also appear with spacing on some labels). A direct match helps avoid ordering mistakes.
What does a Bosch EDC15P+ ECU (0281011823) do?
A Bosch EDC15P+ ECU Engine controller 0281011823 controls key engine parameters on a 1.9 TDI. It manages fuel delivery, processes sensor signals, and communicates with other control modules.
A properly working ECU supports smooth acceleration, stable idle, and consistent performance in both city and highway driving.
What symptoms can a faulty 038906019NJ ECU cause on a Seat Ibiza 1.9 TDI?
A faulty 038906019NJ ECU may cause starting problems, rough running, power loss, warning lights, or diagnostic communication errors. In some cases, the car may behave inconsistently under load.
This 0281011823 / 038906019NJ ECU Engine controller is checked before dispatch, so you receive a tested unit with warranty and fast shipping.
Why are part numbers 0281011823 and 038906019NJ crucial when choosing an ECU?
Part numbers 0281011823 and 038906019NJ help you pick the correct ECU for your specific vehicle setup. Even similar-looking ECUs can differ in configuration or software, which can prevent proper operation after installation.
Before ordering, compare all markings on your original label (including Bosch and OEM references). This simple step significantly reduces the risk of a mismatch.
Does the Volkswagen / Seat Ibiza ECU 0281011823 require coding after installation?
Depending on the vehicle version, the Volkswagen / Seat Ibiza ECU 0281011823 may require adaptation/coding after installation. This is especially relevant when the ECU is linked to the immobilizer and security functions.
Matching both 0281011823 and 038906019NJ makes replacement easier and improves the chance of a trouble-free install.
