to checkout total: €0.00

᛫ E-mail:

 ᛫ In English:
   +48 792 797 344
   +48 32 235 19 75

 ᛫  En Español
    +34 637272785

᛫  Adress:

ul.Mikusińskiego 33
       40-146 Katowice
    Mon - Fri 9:00 - 17:00

Cheap ABS pumps for car such as Alfa Romeo, Audi, BMW, Chevrolet, Chrysler, Citroen, Audi, Renault, Ford

The ABS pump fulfils one of the most important functions in the car that affect its safe use. Its task is to ensure that the road wheels do not get blocked during heavy braking. Thanks to this, the driver does not lose control over the steering wheel and the braking is considerably safer.

Cheap ABS pumps for car

An efficiently operating pump can save the driver from a dangerous accident. This element makes it possible to maximally reduce the speed of the car without losing control and causing the vehicle to skid. It is for this reason that every new car that is currently marketed must be equipped with the ABS system. Its operating principle is the same as in the case of a conventional braking system. The difference is that the ABS has a pump added, called a modulator. It has been cunningly built into the system of various hydraulic lines. This makes it possible to properly adjust the pressure in the braking system if the ABS sensors detect skidding of any individual wheel.

Cheap ABS pumps for car such as Alfa Romeo, Audi, BMW, Chevrolet, Chrysler, Citroen, Audi, Renault, Ford

An ABS pump consists of a small electric engine, electromagnetic valves and a base to which the brake lines are connected. At each ABS pump, there is also a controller with sensors attached to it. It should be stressed that it is a non-dismountable part, an assembly. In the event of failure, it is necessary to replace it with a whole new one or a used one that can be found on the Internet, e.g. by visiting In order to have a pump replaced the best way is to visit a specialist car garage. Not every mechanic will be able to cope with installing a new pump because dismantling of the brake lines requires using appropriate tools and techniques. After fitting in a new ABS pump, it is vital to fill the entire system with braking fluid and take care of proper bleeding. Helpful here will be a diagnostic tester that controls the holes in the pump as it will enable proper execution of the process. Prior to returning the car to the owner a test drive should be done to check if everything is in order.

Sun Mon Tue Wed Thu Fri Sat
1 2
3 4 5 6 7 8 9
10 11 12 13 14 15 16
17 18 19 20 21 22 23
24 25 26 27 28 29 30
Shop is in view mode
View full version of the site
Sklep internetowy od